|
Figure 1 illustrates standard single lip design. The "S" type designs are the single lip oil seal with a garter spring to provide a consistent radial load against the shaft.
Figure 2 illustrates standard double lip designs. The feature of "T" type designs, corresponding to "ES" type, is the additional lip to prevent dirt and corrosion.
- WORKING CONDITION : suitable for "S" and "T" type oil seals
SHAFT
DIAMETER |
(1)NITRILE LIP MAX. CONTINUOUS
SHAFT SPEED |
(2)MAX. CONTINUOUS
PRESSURE |
| GENERAL |
3,500 rpm |
5 psi |
| 0.500 |
8,000 rpm |
5 psi |
| 1.000 |
7,000 rpm |
5 psi |
| 2.000 |
4,500 rpm |
5 psi |
| 3.000 |
3,800 rpm |
5 psi |
| 4.000 |
2,750 rpm |
5 psi |
Note:
(1) in high shaft speed, it's more possible to use high temperature materials such as polyacrylate, silicone or fluoroelastomer.
(2)slightly higher continuous pressure is applied to shaft speed below 200 ft./min.
|
